I wouldn’t advise unpacking your studio from the truck because you don’t have a forklift. The main reason is the plastic. It’s very dense. It’s very durable, but, because of length and the width of it, it’s hard to manhandle, and you’re going to scratch it. I would seriously advise getting a forklift. If you don’t have one, borrow one. If you can’t borrow one, rent one. The ease of getting it off the back of the semi-truck with a forklift is day and night compared to taking all the steel off the pallet and then twenty-something panels of plastic, including supplies.
So, to answer your question, I wouldn’t advise unpacking your pallet piece by piece at all! If you damage a plastic panel, it’s going on your booth, damaged.
FAQ
Can I unload my 360Booth® piece by piece without a forklift?
360Booth advises against it. The large plastic panels are hard to handle and easy to scratch, and a damaged panel will end up on your studio.
What should I do if I don't have a forklift?
Borrow or rent one. Unloading the pallet with a forklift is far easier than removing the steel and twenty-plus plastic panels by hand.
